Your cartThere are no more items in your cart
Impact protectionRiding helmet certified compliant with Directive 89/686/EEC.
AdjustableHarness is adjustable using a buckle under the chin.
Ventilation30 holes and 9 ventilation channels. Forehead air inflow. Ventilated neck piece.
User comfortInner made of breathable mesh fabric and foam for better comfort.
StabilityThe 4-point harness envelopes the head for superior support.
Adjusting the helmet:
For optimal protection, the helmet should be in close contact with the head without squeezing it. When properly adjusted, the helmet should not slide forward, backward, or from side to side, even when you are in motion while riding.
For optimal support, the helmet's harness/chinstrap should go under the throat, not over the chin.
This helmet has been designed to completely or partially absorb impacts to the rider's head in the event of a fall or violent impact. When an impact occurs, the helmet and/or the padding can deform or break to absorb the energy of the impact. DAMAGE MAY NOT BE VISIBLE, BUT ANY HELMET THAT HAS SUFFERED AN IMPACT MUST BE REPLACED.
30 ventilation holes, facing forwards in the direction that the air enters and facing backwards in the direction that heat is evacuated. The polystyrene padding includes aeration vents to circulate air throughout the helmet.
Foam padding in a 2D and 3D breathable mesh fabric liner for greater comfort and ventilation. The inner liner is removable for cleaning and care. Rip-tab fasteners make it easy to remove. Machine wash the liner at 30° and allow to air dry.
The harmonised standard EN 1384 was repealed in October 2014. Until a new version is issued, in order for them to be sold in Europe, all helmets produced after 4 November 2014 must undergo testing and be CE marked. This mark must be supported by compliance with either Directive 89/686/EEC, or document VG1 01.040 2014-12.
Information on standards:
EN 1384 certified helmets can still be worn in training and competitions. However, some organizations may require other standards for their competitions. When in doubt, please consult the event organisers.
Steam brush the outside.
Information / Concept / Technology
Main lining : 100.0% Polystyrene (EPS) - Expanded
UTAC, independent laboratory, appointed by the French authorities to conduct tests to establish compliance of safety equipment in accordance with the directives issued by the European Commission in Brussels. Recognised for its technical expertise, the organisation is one of the official laboratories of EuroNCAP, the European independent body. UTAC also conducts tests for the United Nations. It has approved this helmet for use throughout the EU.
Tested in an independent laboratory in compliance with current regulations.
Store away from heat sources such as heating appliances or the parcel shelf of a car in the sun. This can deteriorate the protective performance of the polystyrene inner padding.
Steam brush the outside.
View products ...